Hyundai Kona: Evaporative Emission Control System / Fuel Tank Air Filter Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Lift the vehicle.
3.
Remove the canister assembly.
(Refer to Emission Control System - "Canister")
4.
Remove the canister protector (A) after loosening bolt & clips.

5.
Remove the canister cover (A) after loosening bolt & clips.

6.
Remove the clip, and then separate the fuel tank air filter (B) from the canister after rotating it in the direction of the arrow in the figure.

Installation
1.
Install in the reverse order of removal.
Canister Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Lift the vehicle. 3. Dis ...

Fuel Filler Cap Description and operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the f ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: DC/DC Converter Repair procedures
Removal [200W] 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disc ...

Hyundai Kona (OS) 2018-2026 Owners Manual: 4 Wheel Drive (4WD) LOCK Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you select 4WD Lock mode by pressing the 4WD LOCK button. - The 4WD LOCK mode is to increase the drive power ...

В© 2018-2026 www.hkona.com