Hyundai Kona: Parking Brake System / Parking Brake Switch Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4.
Disconnect the parking brake switch connector (A).

5.
Loosen the screw and then remove the parking brake switch (A).
Tightening torque :
1.96 - 2.94 N.m (0.2 - 0.3 kgf.m, 1.44 - 2.16 lb-ft)

Installation
1.
To install, reverse removal procedure.
Parking Brake Lever Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the parking brake. 3. ...

Parking Brake Cable Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Release the parking brake. 3. ...

Other information:

Hyundai Kona (OS) 2018-2025 Service Manual: Front Wheel Speed Sensor Repair procedures
Removal 1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable. 2. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 3. Remove t ...

Hyundai Kona (OS) 2018-2025 Service Manual: Repair procedures
Adjustment Glass Adjustment    • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove t ...

© 2018-2025 www.hkona.com