Hyundai Kona: Parking Brake System / Parking Brake Cable Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Release the parking brake.
|
| 3. |
Remove the floor console assembly.
(Refer to Body - "Floor Console")
|
| 4. |
Loosen the parking brake cable adjust nut (A).
|
| 5. |
Separate the parking brake cable retainer (A) and then remove the parking
brake cable.
|
| 6. |
Raise the vehicle, and make sure it is securely supported.
|
| 7. |
Remove the rear wheel and tire (A) from the rear hub.
|
| 8. |
Remove the parking brake cable fixing clip (A).
|
| 9. |
Pull the operation lever as a counterclock-wise direction and then remove
the parking cable (A) from the caliper.
|
| 10. |
Remove the floor under cover (A).
|
| 11. |
Loosen the parking brake cable mouting bolts and then remove the cable
(A).
|
| Installation |
| 1. |
To install, reverse removal procedure.
|
| 2. |
Tension the parking brake cable by tightening the adjusting nut, until
the operating levers on both calipers lift from the stop, up to a distance
of (A) and (D) between operating lever (B) and stopper (C).
|
| 3. |
Release the parking brake lever fully, and check that parking brakes
do not drag when the rear wheels are turned. Readjust if necessary.
|
| 4. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
Parking Brake Switch Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
...
Other information:
Hyundai Kona (OS) 2018-2026 Owners Manual: Rear view monitor
The Rear view monitor will activate when the engine is running and the shift
lever is in the R (Reverse) position.
This is a supplemental system that shows behind the vehicle through the mirror
or navigation display while backing-up.
WARNING
The Rear view monitor is not a safety device. It only s ...
Hyundai Kona (OS) 2018-2026 Service Manual: Fuel Pump Control Module (FPCM) Repair procedures
Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel
Line")
2.
Remove the rear seat cushion.
(Refer to Body - "Rear Seat Assembly&q ...
