Hyundai Kona: Front Seat Belt / Height Adjust Repair procedures

Replacement
1.
Remove the front seat belt upper anchor.
(Refer to Front Seat Belt - "Front Seat Belt Pretensioner")
2.
After loosening the mounting bolts, then remove the height adjust (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

3.
To install, reverse removal procedure.
  
Replace any damaged clips (or pin-type retainers).
Height Adjust Components and components location
Component Location 1. Height adjust ...

Front Seat Belt Buckle Components and components location
Component Location 1. Front seat belt buckle ...

Other information:

Hyundai Kona (OS) 2018-2024 Service Manual: Rear Seat Latch Repair procedures
Replacement [LH]    • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the relat ...

Hyundai Kona (OS) 2018-2024 Service Manual: Compressor Description and operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature re ...

© 2018-2024 www.hkona.com