Hyundai Kona: Hood / Hood Assembly Repair procedures

Replacement

•	Be careful not to damage the hood and body.

•	Removing or installing the hood requires an assistant.

•	When removing the clips, use a clip remover.

After loosening the hood hinge (A) mounting bolts, remove the hood assembly (B).

Tightening torque :

21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)

To install, reverse removal procedure.

•	Make sure the hood locks / unlocks and opens / closes properly.

•	Adjust the hood alignment.

Component Location 1. Hood assembly ...

Replacement 1. Using a clip remover, remove the clips and then the hood insulator pad (A). ...

Hyundai Kona (OS) 2018-2026 Service Manual: Fuel Tank Air Filter Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Lift the vehicle. 3. Remove the canister assembly. (Refer to Emission Control System - "Canister") ...

Hyundai Kona (OS) 2018-2026 Service Manual: General information
Lift and Support Points • When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the lu ...