Hyundai Kona: Engine Control System / Knock Sensor (KS) Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the intake manifold (Refer to Engine Mechanical System - "Intake Manifold")

3.	Remove the installation bolt (A), and then remove the sensor from the cylinder block.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

Install in the reverse order of removal.

Knock sensor installation bolt :

18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)

Knock Sensor (KS) Schematic diagrams

Circuit Diagram Harness Connector ...

Heated Oxygen Sensor (HO2S) Description and operation

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output vol ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Charging System Warning Light
This warning light illuminates: • When there is a malfunction with either the alternator or electrical charging system. If there is a malfunction with either the alternator or electrical charging system: 1. Drive carefully to the nearest safe location and stop your vehicle. 2. Turn the engine o ...

Hyundai Kona (OS) 2018-2026 Service Manual: Troubleshooting
Troubleshooting Trouble symptom Probable cause Remedy Displayed the warning lamp "E" (Driving is only possible with 1 / R gear) Not performed DCT learning Perform the DCT manual learning procedu ...