Hyundai Kona: Immobilizer System / Immobilizer Control Unit Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
|
| 3. |
Disconnect the connector of the immobilizer unit and then remove
the immobilizer unit (A) after loosening a bolt.
|
| Installation |
| 1. |
Install the immobilizer control unit after connecting the unit connector.
|
| 2. |
Install the main crash pad assembly.
|
| 3. |
Connect the negative (-) battery terminal.
|
Repair procedures
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM(ECM) or
when providing additional keys ...
Antenna Coil Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column shroud panel.
(Refer to ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Description and operation
Description
The Tire Pressure Monitoring System (TPMS) monitors the pressure and temperature
inside the tire in order to warn the driver of changes in pressure which may
influence the operation of the vehicle. The TPMS control module analyzes wireless
information fro
In ...
Hyundai Kona (OS) 2018-2026 Service Manual: Electric WGT Control Actuator Description and operation
Desrcription
The Electric WGT Control Actuator is installed on the turbocharger. It operates
the vain in the Waste Gate Turbocharger (WGT) and regulates the compressed air
amount by the ECM's PWM signal. This actuator consists of a DC motor which actuates
the vane, a 2-s ...
