Hyundai Kona: Dual Clutch Transmission Control System / Input shaft speed sensor 2 Description and operation

Description
Components location : DCT (Dual Clutch Transmission)

Function
The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM).
It provides important input information for electric control.
The information is needed in all operations, including feedback control, gear shift control and failure detection of other sensors.
Input shaft speed sensor 2 Specifications
Specification Item Specification Type Hall effect sensor Operation condition (°C)°F -40 to 257°F (- ...

Input shaft speed sensor 2 Schematic diagrams
Circuit Diagram ...

Other information:

Hyundai Kona (OS) 2018-2023 Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal [Tortion Beam Axle Type] 1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable. 2. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. ...

Hyundai Kona (OS) 2018-2023 Service Manual: Dual Clutch Assembly Repair procedures
Removal 1. Remove the dual clutch transmission from the vehicle. (Refer to Dual Clutch System - "DCT") 2. Remove the retaining ring (A) and then removing the spline hub (B). 3. Remove ...

© 2018-2023 www.hkona.com