Hyundai Kona: Dual Clutch Transmission Control System / Input shaft speed sensor 2 Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / DCT (Dual Clutch Transmission) System / Dual Clutch Transmission Control System / Input shaft speed sensor 2 Repair procedures

Removal

1.	Remove the cleaner assembly and air duct. (Refer to Engine Mechainical System - "Air Cleaner")

2.	Disconnect the Input shaft speed sensor connector (A).

3.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

4.	Remove the ECM. (Refer to Engine Cotrol System - "ECM")

5.	Remove the clutch actuator. (Refer to Dual Clutch Transmission Control System - "Clutch Actuator")

Remove the input shaft speed sensor (A).

Tightening torque :

9.8 - 11.8 N.m (1.0 - 1.2kgf.m, 7.2 - 8.7 lb-ft)

Installation

To install, reverse the removal procedure.

•	Before installing the input speed sensor, check the assembled state of the O-rings (A) and shuold apply gear oil to surface of O-rings.

Input shaft speed sensor 2 Schematic diagrams

Circuit Diagram ...

Inhibitor Switch Components and components location

Components 1. Inhibitor switch 2. Manual control lever ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Air intake control (7)
This is used to select outside (fresh) air position or recirculated air position. To change the air intake control position, press the control button. Recirculated air position With the recirculated air position selected, air from the passenger compartment will be drawn through the heating system ...

Hyundai Kona (OS) 2018-2026 Service Manual: Injector Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is withi ...