Hyundai Kona: Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the IATS connector.
|
| 3. |
Measure resistance between the IATS terminals 3 and 4.
|
| 4. |
Check that the resistance is within the specification.
|
Specification : Refer to "Specification"
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor from the
surge tank.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| • |
Insert the sensor in the installation hole and be careful not
to damage.
|
|
| 1. |
Install in the reverse order of removal.
|
Manifold absolute pressure sensor installation bolt :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
|
|
Circuit Diagram
Harness Connector
...
Description
Ambient Temperature Sensor (ATS) is installed on the front-end module and senses
the ambient temperature. ECM receives not only the intake air temperatue but
also the ...
Intake Air Temperature Sensor (IATS) Schematic diagrams
Ambient Temperature Sensor (ATS) Description and operation