Hyundai Kona: Liftgate / Liftgate Lift Repair procedures

Replacement
  
Take care to not let the liftgate fall on you as the lifts are removed. Have a helper hold the liftgate open, or use a secure method to hold it open.
1.
Using a screwdriver, lift up slightly the socket clips (A) of both ends on the lifter (B), and then remove the lifter from the bracket.

2.
Push the socket of the lifter into the bracket for installation.
  
Make sure the liftgate locks and opens properly and locks securely.
Liftgate Trim Repair procedures
Replacement [Liftgate lower trim]    • Put on gloves to prevent hand injuries. ...

Liftgate Weatherstrip Repair procedures
Replacement 1. Remove the liftgate weatherstrip (A).    • ...

Other information:

Hyundai Kona (OS) 2018-2020 Service Manual: ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 7° TPS TPS 1 fault ECM looks at TPS2 TPS 2 fault ECM looks at TPS1 TPS 1,2 fault ...

Hyundai Kona (OS) 2018-2020 Service Manual: Vacuum Pump Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Check the safty after uplift the vehicle with lift. 3. Remove the under cover. (Refer to Engine Mechanical System - ...

© 2018-2020 www.hkona.com