Hyundai Kona: Power Door Mirrors / Power Door Mirror Switch Repair procedures

Inspection
[Power Window Switch]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver door trim.
(Refer to Body - "Front Door Trim")
3.
Disconnect the power mirror switch connector from the door trim.

4.
Check for continuity between the terminals in each switch position according to the table.
[Power Mirror Switch]

[Power Folding Mirror Switch]

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Remove the power window assembly (A).

Installation
1.
Install the power window switch assembly.
2.
Install the front door trim after connect the connector.
3.
Connect the negative (-) battery terminal.
  
Make sure that the switch connectors are plugged in properly.
Check the power door mirror system for normal operation.
Power Door Mirror Switch Schematic diagrams
Circuit Diagram Mirror folding switch Mirror switch ...

Power Door Mirror Actuator Components and components location
Components 1. BCW Indicator 2. Side repeater lamp ...

Other information:

Hyundai Kona (OS) 2018-2025 Service Manual: ICM (Integrated Circuit Module) Relay Box Repair procedures
Inspection Out Side Mirror Folding Relay Check for continuity between the terminals. 1. There should be continuity between the No.9 and No.19 terminals when power and ground are connected to the No.10 and No.20 in the ICM-B. ...

Hyundai Kona (OS) 2018-2025 Service Manual: Components and components location
Components Location 1. PCV Valve 2. Canister 3. Purge Control Solenoid Valve (PCSV) 4. Fuel Tank Air Filter 5. Fuel Level Sensor (FLS) 6. Catalytic Converter (WCC) 7. Gasoline Particulate Filter (GPF) 1. PCV Valve ...

© 2018-2025 www.hkona.com