Hyundai Kona: Engine Control System / RCV Control Solenoid Valve Description and operation

Hyundai Kona (OS) 2018-2023 Service Manual / Engine Control / Fuel System / Engine Control System / RCV Control Solenoid Valve Description and operation

Description
RCV (Recirculation Valve) Control Solenoid Valve is installed on the cooling pan motor top and operates the RCV actuator which controls the by-pass passage of the turbo-charger compressor.
When the throttle valve is closed during engine running [Tip-out], crash noise of the impeller will occur because of rapid increasing of the boost pressure. So, in this case, in order to prevent this phenomenon, ECM maintains the appropriate boost pressure by opening the by-pass passage.

Electric WGT Control Actuator Schematic diagrams
Circuit Diagram ...

RCV Control Solenoid Valve Specifications
Specification Item Specification Coil Resistance (Ω) 28.3 - 31.1 [20°C (68°F)] ...

Other information:

Hyundai Kona (OS) 2018-2023 Service Manual: Heated Oxygen Sensor (HO2S) Description and operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance with the air/fuel ratio. The sensor must be hot in order to operate no ...

Hyundai Kona (OS) 2018-2023 Service Manual: Rear Combination Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the outside rear combination lamp assembly after disconnecting the connector. 3. Remove the bulb (A ...

© 2018-2023 www.hkona.com