Hyundai Kona: Body Side Molding / Rear Spoiler Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Spoiler Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Remove the tail gate upper trim. (Refer to Tail Gate - "Tail Gate Trim")

2.	Disconnect the high mounted stop lamp connector (A).

3.	Disconnect the rear washer nozzle (A).

4.	Remove the rear spoiler cap (A).

After loosening the mounting nuts, remove the rear spoiler (A).

Tightening torque :

5.9 - 6.4 N.m (0.6 - 0.65 kgf.m, 4.3 - 4.7 lb-ft)

6.	After loosening the mounting screws, remove the high mounted stop lamp (A).

To install, reverse the removal procedure.

•	Make sure the connector is connected properly.

•	Replace any damaged clips (or pin-type retainers).

Rear Spoiler Components and components location

Component Location 1. Rear spoiler ...

Fender Garnish Repair procedures

Replacement • Put on gloves to prevent hand injuries. ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Paddle shifter
The paddle shifter is functional when the shift lever is in the D (Drive) position or the manual shift mode. With the shift lever in the D position The paddle shifter will operate when the vehicle speed is more than 10km/h. Pull the [+] or [-] paddle shifter once to shift up or down one gear and t ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Using the Tire Mobility Kit
CAUTION Detach the speed restriction sealant bottle onto the valve. label (0) from the sealant bottle (1), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast. 1. Shake the sealant bottle. 2. Screw the connection hose ...