Hyundai Kona: Body Side Molding / Fender Garnish Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Fender Garnish Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Using a screwdriver or remover, remove the fender garnish (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Rear Spoiler Repair procedures

Replacement • Put on gloves to prevent hand injuries. ...

Quarter Garnish Repair procedures

Replacement • Put on gloves to prevent hand injuries. ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Rear Door Belt Inside Weatherstrip Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. To install, reverse removal procedure. ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Manual transmission operation
The manual transmission has 6 forward gears. The transmission is fully synchronized in all forward gears so shifting to either a higher or a lower gear is easily accomplished. WARNING Before leaving the driver's seat, always make sure the shift lever is in 1st gear when the vehicle is parked on a ...