Hyundai Kona: Body Side Molding / Quarter Garnish Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Using a screwdriver or remover, remove the quarter garnish (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Replacement • Put on gloves to prevent hand injuries. ...

Replacement • Put on gloves to prevent hand injuries. ...

Hyundai Kona (OS) 2018-2026 Service Manual: Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (A) and then re ...

Hyundai Kona (OS) 2018-2026 Service Manual: ICM (Integrated Circuit Module) Relay Box Repair procedures
Inspection Out Side Mirror Folding Relay Check for continuity between the terminals. 1. There should be continuity between the No.9 and No.19 terminals when power and ground are connected to the No.10 and No.20 in the ICM-B. ...