Hyundai Kona: Body Side Molding / Side Sill Molding Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Side Sill Molding Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Using a remover, remove the side sill molding (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Quarter Garnish Repair procedures

Replacement • Put on gloves to prevent hand injuries. ...

Roof Side Molding Repair procedures

Replacement • Put on gloves to prevent hand injuries. ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Vehicle Stability Management
The Vehicle Stability Management (VSM) is a function of the Electronic Stability Control (ESC) system. It helps ensure the vehicle stays stable when accelerating or braking suddenly on wet, slippery and rough roads where traction over the four tires can suddenly become uneven. WARNING Take the fo ...

Hyundai Kona (OS) 2018-2026 Service Manual: Exhaust Gas Temperature Sensor (EGTS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the connector of exhaust gas temperature sensors #1/#2. 3. Measure resistance between sensor signal terminal and ground terminal. 4. ...