Hyundai Kona: Body Side Molding / Roof Side Molding Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
1.
Using a screwdriver or remover, remove the roof side molding (A).

2.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).
Side Sill Molding Repair procedures
Replacement    • Put on gloves to prevent hand injuries. ...

Roof Rack Components and components location
Components Location 1. Roof rack assembly ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Troubleshooting
Failure Diagnosis 1. In principle, ESP and TCS controls are prohibited in case of ABS failure. 2. When ESP or TCS fails, only the failed system control is prohibited. 3. However, when the solenoid valve relay s ...

Hyundai Kona (OS) 2018-2026 Service Manual: Water Temperature Control Assembly Repair procedures
Removal and Installation 1. Disconnect the battery "-" terminal. 2. Remove the engine cover. (Refer to Engine and Transaxle Assembly - "Engine Cover") 3. Remove the engine room unde ...

© 2018-2026 www.hkona.com