Hyundai Kona: Rear Suspension System / Rear torsion beam axle Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Suspension System (NON-ECS) / Rear Suspension System / Rear torsion beam axle Repair procedures

Removal

1.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the rear wheel and tire (A) from front hub.

Tightening torque :

107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)

•	Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

3.	Remove the brake caliper from the torsion beam axle. (Refer to Brake System - "Rear Disc Brake")

4.	Remove the rear hub carrier. (Refer to Dirveshaft and axle - "Rear Hub - Carrier")

Loosen the bolt & nut and then disconnect the rear shock absorber (A) from the torsion beam axle.

Tightening torque :

98.1 - 117.7 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.8 lb-ft)

6.	Remove the coil spring.

7.	Disconnect the rear wheel speed sensor connector (A).

8.	Remove the wheel speed sensor cable bracket (A) and parking brake cable bracket (B).

Remove the torsion beam axle stay mounting bolts (A) and nuts (B) and then removeing the torsion beam axle.

Tightening torque :

98.1 - 117.7 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.8 lb-ft)

10.

Remove the torsion beam axle stay (A).

Tightening torque :

98.1 - 117.7 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.8 lb-ft)

Replacement

[Rear torsion beam axle bush replace]

1.	Remove the rear torsion beam axle from the vehicle. (Refer to Rear Torsion Beam Axle - "Removal")

Using the SST (09551-AL100) and press, replace the bush (A).

•	When press in the bush, press the same direction of the void (A) and the flange direction (B) before detaching.

Installation

1.	Install in the reverse order of removal.

Rear torsion beam axle Components and components location

Components 1. Torsion beam axle 2. Torsion beam axle stay ...

Tires/Wheels

...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Dual clutch transmission shift indicator
This indicator displays which shift lever position is selected. Park :P Reverse : R Neutral : N Drive :D Manual shift mode : D1, D2, D3, D4, D5, D6, D7 Shift Indicator Pop-up The pop-up that indicates the current gear position is displayed in the cluster for about 2 seconds when shifting i ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Driver’s side fuse panel
Inside the fuse/relay box covers, you can find the fuse/relay label describing fuse/relay names and ratings. Information Not all fuse panel descriptions in this manual may be applicable to your vehicle. It is accurate at the time of printing. When you inspect the fuse box on your vehicle, refer ...