Hyundai Kona: Steering System / Repair procedures

Service Adjustment Procedure
Steering Wheel Play Inspection
1.
Turn the steering wheel so that the front wheels can face straight ahead.
2.
Measure the distance the steering wheel can be turned without moving the front wheels.
Standard value : 30 mm (1.18 in.) or less

3.
If the play exceeds standard value, inspect the steering column, shaft, and linkages.
Checking Stationary Steering Effort
1.
Position the vehicle on a level surface and place the steering wheel in the straight ahead position.
2.
Start the engine and turn the steering wheel from lock to lock several times to warm up the power steering fluid.
3.
Attach a spring scale to the steering wheel. With the engine speed 900 - 1100rpm, pull the scale and read it as soon as the tires begin to turn.
Standard value : 3.0 kgf or less

4.
If the measured value exceeds standard value, inspect the power steering gear box and pump.
Troubleshooting
Troubleshooting Symptom Probable cause Remedy play in steering Loose yoke plug Retighten ...

Steering wheel
...

Other information:

Hyundai Kona (OS) 2018-2021 Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Waveform This example shows a typical Crankshaft Position Sensor(CKPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CKPS signal is used to detect the piston's position a ...

Hyundai Kona (OS) 2018-2021 Service Manual: Power Seat Motor Repair procedures
Inspection Power Seat Motor 1. Disconnect the connectors for each motor. [Slide Motor] [Rear Height Motor] [Front Height Motor] [Reclining Motor] [Lumbar Support ...

© 2018-2021 www.hkona.com