| Adjustment |
| Inspect Glass Alignment |
| 1. |
Inspect the step height between the roof panel (A) and the glass weatherstrip
(B) and then adjust it if necessary.
|
| 2. |
Adjust the height of the glass by slighly loosening the screws (A).
|
| When To Initialize The Motor |
| 3. |
After initial vehicle assembly.
|
| 4. |
If the initial value is erased or damaged because of short power electric
discharge during operation.
|
| 5. |
After using the manual handle.
|
| Operating The Sunroof Emergency Handle |
| 6. |
Use the sunroof emergency handle to close or open the sunroof manually
if the sunroof cannot be closed electronically due to motor or controller
electrical malfunction.
|
| 7. |
If needed, initialize the sunroof according to the initialization method.
Whenever the vehicle battery is disconnected or discharged, or you use
the emergency handle to operate the sunroof, you have to reset your
sunroof system as follows :
|
Components and components location
Sunroof Glass Components and components locationHyundai Kona (OS) 2018-2026 Service Manual: General information
General Troubleshooting
Information
Before Troubleshooting
1.
Check applicable fuses in the appropriate fuse/relay box.
2.
Check the battery for damage, state of charge, and clean and tight connections.
(Refer to Engine Ele ...
Hyundai Kona (OS) 2018-2026 Service Manual: Components and components location
Component Location
[Engine Room]
1. Engine room junction block
[Interior Relay]
1. Smart junction block (SJB)
2. ICM relay block
...