Hyundai Kona: Crankcase Emission Control System / Repair procedures

Inspection

1.	After disconnecting the vapor hose from the PCV valve, remove the PCV valve.

2.	Reconnect the PCV valve to the vapor hose.

Inspect the PCV vlave operation.

(1)	Run the engine at idle.

(2)	Put a finger on the open end of the PCV valve.

(3)	Make sure that intake manifold vaccum can be felt.

•	The plunger inside the PCV valve will move back and forth at vacuum.

4.	If the vacuum is not felt, clean or replace the vapor hose.

Schematic Diagram ...

Operation Principle ...

Hyundai Kona (OS) 2018-2020 Service Manual: Sunroof Assembly Repair procedures
Replacement • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. � ...

Hyundai Kona (OS) 2018-2020 Service Manual: Engine Control Module (ECM) Schematic diagrams
ECM Terminal and Input/Output signal ECM Terminal Function Connector [A] Pin No Description Connected to 1 Ignition coil (Cylinder #4) control output Ignition coil (Cylinder #4) ...