The sunroof may need to be reset if the following conditions occur:
- The battery is discharged or disconnected or the sunroof fuse has been replaced
or disconnected
- The sunroof control lever is not operating correctly
To reset the sunroof, perform the following steps:
1. Place the ignition switch to the ON position or start the engine. It is recommended to reset the sunroof while the engine is running.
2. Push the control lever forward.The sunroof will close completely or tilt depending on the condition of the sunroof.
3. Release the control lever until the sunroof does not move.
4. Push the control lever forward about 10 seconds.
- When the sunroof is in the close position :
The glass will tilt and slightly move up and down.
- When the sunroof is in the tilt position:
The glass will slightly move up and down.
Do not release the lever until the operation is completed.
If you release the lever during operation, try again from step 2.
5. Within 3 seconds, push the control lever forward until the sunroof operates as follows:
Tilt down Slide Open Slide Close.
Do not release the lever until the operation is completed.
If you release the lever during operation, try again from step 2.
6. Release the sunroof control lever after all operation has completed. (The sunroof system has been reset.)
Information
Sunshade
Sunroof open warningHyundai Kona (OS) 2018-2026 Service Manual: Inhibitor Switch Repair procedures
Inspection
Inspection Flow
Items to check
1.
Inspect DTC code.
2.
Inspect whether N setting matches.
–
Adjust N setting (Refer to Dual Clutch Transmission Control
System - "Inhibi ...
Hyundai Kona (OS) 2018-2026 Owners Manual: Sliding the sunroof
Pressing the sunroof control lever backward or forward momentarily to the second
detent position completely opens or closes the sunroof even when the switch is released.
To stop the sunroof at the desired position while the sunroof is in operation, press
the sunroof control lever backward or forw ...