Hyundai Kona: Lighting System / Room Lamp Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body Electrical System / Lighting System / Room Lamp Repair procedures

Removal

[Room Lamp]

1.	Disconnect the negative (-) battery terminal.

Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp.

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

3.	If it is necessary to replace the bulb, remove the bulb after disengaging the room lamp lens.

Disengage the room lamp after loosening the mounting screws.

•	When removing the room lamp, be careful of the direction in which the tool is inserted.

•	Use caution when inserting the tool in the opposite direction, as the room lamp is damaged.

5.	Remove the room lamp assembly after disconnect the room lamp connector.

[Vanity Lamp]

1.	Separate the vanity Lamp (A) from the roof trim after disengaging the mounting clip (B).

Installation

[Room Lamp]

1.	Install the room lamp after connect the connector.

2.	Install the room lamp lens

3.	Connect the negative (-) battery terminal.

[Vanity Lamp]

1.	Install the vanity lamp.

2.	Connect the negative (-) battery terminal.

Door Mirror Lamp Repair procedures

Remove 1. Disconnect (-) battery terminal. 2. Remove door mirror assembly. (Refer to Body - "Mirror" ...

Overhead Console Lamp Repair procedures

Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Special service tools
Special Service Tools Tool (Number and Name) Illustration Use 09200-3N000 Engine support fixture (Beam) Removal and installation of the transaxle. Use this beam (SST No. : 09200-3N000) with ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Securing a Child Restraint System with the “ISOFIX Anchorage System”
To install an i-Size or ISOFIX-compatible Child Restraint System in either of the rear outboard seating positions: 1. Move the seat belt buckle away from the ISOFIX anchorages. 2. Move any other objects away from the anchorages that could prevent a secure connection between the Child Restraint Sys ...