| Components (1) |

|
No |
Connector A |
Connector B |
Connector C |
|
1 |
BAT(+)_Signal |
IGN 2_Relay output |
Immobizer antenna_Power |
|
2 |
BAT(+)_Power |
IGN 1_Relay output |
Wheel spped sensor |
|
3 |
Interior antenna 1 GND_output |
- |
SSB switch1 |
|
4 |
Bumpper antenna GND_output |
- |
- |
|
5 |
Interior antenna 2 GND_output |
ESCL CAN |
ESCL Unlock switch |
|
6 |
Assist door antenna GND_output |
EMS CAN |
"P" position switch |
|
7 |
Trunk antenna GND_output |
B-CAN (High) |
Brake switch |
|
8 |
Driver's door antemma GND_output |
B-CAN (Low) |
IG2 |
|
9 |
- |
C-CAN (Low) |
IG1 |
|
10 |
SSB IIIumination(+) |
C-CAN (High) |
Starter relay |
|
11 |
Exterior buzzer |
- |
Immobizer antenna_GND |
|
12 |
ESCL (+) |
ACC_Relay output |
RPM signal |
|
13 |
- |
- |
SSB switch2 |
|
14 |
Interior antenna 1 power_output |
GND |
Driver's togle button switch_signal |
|
15 |
Bumpper antenna power_output |
- |
Passenger togle button switch_signal |
|
16 |
Interior antenna 2 power_output |
SSB LED(ACC) |
Starter relay feedback signal |
|
17 |
Trunk antenna power_output |
SSB LED(IGN) |
- |
|
18 |
Assist door antenna power_output |
- |
ACC signal |
|
19 |
Assist door antenna power_output |
- |
- |
|
20 |
- |
SSB IIIumination(-) |
GND power |
|
21 |
ESCL Enable signal |
- |
|
|
22 |
ESCL Enable GND |
WCM |

Smart Key Unit Schematic diagramsHyundai Kona (OS) 2018-2026 Service Manual: Wheel Repair procedures
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
•
Wh ...
Hyundai Kona (OS) 2018-2026 Owners Manual: Engine compartment fuse panel
Inside the fuse/relay box covers, you can find the fuse/relay label describing
fuse/relay names and ratings.
Information
Not all fuse panel descriptions in this manual may be applicable to your vehicle.
It is accurate at the time of printing. When you inspect the fuse box on your vehicle,
refer ...