Hyundai Kona: Crash Pad / Steering Column Shroud Panel Repair procedures

Replacement

[Steering column shroud lower panel]

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the crash pad lower panel. (Refer to Crash Pad - "Crash Pad Lower Panel")

2.	Loosen the mounting screws by turning the steering wheel to the left and right, and remove the steering column shroud lower panel (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

[Steering column shroud upper panel]

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the steering column shroud upper panel (A).

2.	Using a screwdriver or remover, remove the steering column shroud upper panel (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Component Location 1. Steering column shroud lower panel 2. Steering column shroud upper panel ...

Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

Hyundai Kona (OS) 2018-2024 Service Manual: RCV Control Solenoid Valve Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the RCV connector. 3. Measure resistance between the RCV terminals 1 and 2. 4. Check that the resistance is within the spec ...