| Troubleshooting |
|
Symptom |
Passible Cause |
Remedy (Refer to page) |
|
Water leaks from sunroof |
Deteriorated roof lid weatherstrip |
Replace |
|
Excessive roof lid-to-body clearance and improperly fitted weatherstrip |
Adjust |
|
|
Wind noise around sunroof |
Loose or deformed deflector, gaps in body work |
Retighten adjust or replace |
|
Noise created by moving sunroof lid |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
|
Loose guide rails and lid |
Retighten |
|
|
Motor runs but sunroof does not move or moves only partially |
Foreign particles lodged in guide rail |
Adjust or replace |
|
Incorrect engagement of motor pinion with drive cable |
||
|
Decrease in motor's clutch slipping force |
||
|
Increased sunroof sliding resistance or interference of sunroof with drive
cables, weatherstrip, etc. due to abnormal adjustment of sunroof |
||
|
Noise in motor (clutch slipping noise from motor when sunroof is fully opened
or closed) is considered as normal |
Incorrect engagement of motor pinion with drive cable |
Check pinion installation and Re-tighten motor |
|
Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
|
Worn out or deformed drive cable |
Replace |
|
|
Door glass fails to operate up and down |
Incorrect window glass installation |
Adjust position |
|
Damaged or faulty regulator arm or regulator |
Correct or replace |
|
|
Door does not open or close completely |
Incorrect door installation |
Adjust position |
|
Defective door check assembly |
Correct or replace |
|
|
Door hinge requires grease |
Apply grease |
|
|
Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
|
Incorrectly installed hood |
Adjust |
|
|
Incorrect hood bumper height |
Adjust |
|
|
Water leaks through windshield and rear window |
Defective seal |
Fill with sealant |
|
Defective flange |
Correct |
Special service tools
FenderHyundai Kona (OS) 2018-2026 Service Manual: TPMS Sensor Description and operation
Description
1.
General description
WU is a sensor placed in the tire that reports pressure and temperature.
The WU is mounted inside the wheels, fixed to the valve. The angle between
the valve and the housing of the WU is variable.
Th ...
Hyundai Kona (OS) 2018-2026 Service Manual: TPMS Sensor Repair procedures
Replacement
1.
Remove the wheel and tire.
2.
Remove the valve core and deflate the tire.
3.
Install the wheel tire to the tire change machine.
4.
Push the tire as the illust ...