Hyundai Kona: Driveshaft and axle (2WD-FF) / Troubleshooting
Hyundai Kona (OS) 2018-2026 Service Manual / Driveshaft and axle (2WD-FF) / Troubleshooting
| Troubleshooting |
|
Trouble Symptom |
Probable cause |
Remedy |
|
Vehicle pulls to one side |
Scoring of driveshaft ball joint |
Replace |
|
Wear, rattle or scoring of wheel bearing |
Replace |
|
|
Defective front suspension and steering |
Adjustment or Replace |
|
|
Vibration |
Wear, damage or bending of driveshaft |
Replace |
|
Driveshaft rattle and hub serration |
Replace |
|
|
Wear, rattle or scratching of wheel bearing |
Replace |
|
|
Shimmy |
Defective wheel balance |
Adjustment or Replace |
|
Defective front suspension and steering |
Adjustment or Replace |
|
|
Excessive noise |
Wear, damage or bending of driveshaft |
Replace |
|
Rattle of driveshaft and worn hub splines |
Replace |
|
|
Wear, rattle or scoring of wheel bearing |
Replace |
|
|
Loose hub nut |
Adjustment or Replace |
|
|
Defective front suspension and steering |
Adjustment or Replace |
Special service tools
Special Service Tools
Tool (Number and Name)
Illustration
Use
09568-1S100
Ball joint remover
Ball j ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (A) and then re ...
Hyundai Kona (OS) 2018-2026 Owners Manual: AUTO STOP Indicator Light
This indicator light illuminates:
When the engine enters the Idle Stop mode of the ISG (Idle Stop and Go)
system.
This indicator light blinks:
When the automatic starting occurs, the AUTO STOP indicator on the cluster
will blink for 5 seconds.
Information
When the engine automatically sta ...
В© 2018-2026 www.hkona.com
