Hyundai Kona: Driveshaft and axle (2WD-FF)
Hyundai Kona (OS) 2018-2026 Service Manual / Driveshaft and axle (2WD-FF)
- Specifications
- Special service tools
- Troubleshooting
- Front Axle Assembly
- Front Hub / Knuckle / Tone Wheel Components and components location
- Front Hub / Knuckle / Tone Wheel Repair procedures
- Driveshaft Assembly
- Front Driveshaft Components and components location
- Front Driveshaft Repair procedures
- TJ Joint Components and components location
- TJ Joint Repair procedures
- Dynamic Damper Components and components location
- Dynamic Damper Repair procedures
- BJ Boot Components and components location
- BJ Boot Repair procedures
- Rear Axle Assembly
- Rear Driveshaft Assembly
- Propeller Shaft Assembly
- Differential Carrier Assembly
Pressure Sensor Repair procedures
Inspection
•
If you have trouble code related to the pressure sensor check
pre ...
Specifications
Specification
Items
Joint type
Outer side
Inner side
Front driveshaft
GAMMA 1.6
Joint ty ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Condition
Output Voltage (V)
...
Hyundai Kona (OS) 2018-2026 Service Manual: Vacuum Pump Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Check the safty after uplift the vehicle with lift.
3.
Remove the under cover.
(Refer to Engine Mechanical System - ...
© 2018-2026 www.hkona.com
