Hyundai Kona: Driveshaft Assembly / BJ Boot Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Driveshaft and axle (2WD-FF) / Driveshaft Assembly / BJ Boot Repair procedures

Removal

1.	Remove the front driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft")

2.	Remove the TJ joint assembly. (Refer to Driveshaft Assembly - "TJ Joint")

3.	Remove the Dynamic damper. (Refer to Driveshaft Assembly - "Dynamic Damper")

4.	Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.	Remove the BJ boot.

Installation

1.	Install in the reverse order of removal.

Using the SST(09495-3K000), secure the BJ boot bands.

•	Do not reuse the boot band.

3.	Install the TJ joint assembly. (Refer to Driveshaft Assembly - "TJ joint")

4.	Install the front driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft")

5.	Check the alignment. (Refer to Suspension System - "Alignment")

BJ Boot Components and components location

Components (1) [Gamma 1.6 T-GDI, Nu 2.0 MPI] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. ...

Rear Axle Assembly

...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: In case of an emergency while driving
If the engine stalls while driving Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. Turn on your hazard warning flasher. Try to start the engine again. If your vehicle will not start, we recommend that you contact an authorized HYUNDAI deale ...

Hyundai Kona (OS) 2018-2026 Service Manual: Oil Seal Repair procedures
Replacement 1. Remove the trasfer assembly. (Refer to 4WD System - "Trasfer Assembly") 2. Remove the oil seal (A). 3. Remove the oil seal (A). Install the new oil seal with SST ...