Hyundai Kona: Driveshaft and axle (2WD-FF) / Driveshaft Assembly
- Front Driveshaft Components and components location
- Front Driveshaft Repair procedures
- TJ Joint Components and components location
- TJ Joint Repair procedures
- Dynamic Damper Components and components location
- Dynamic Damper Repair procedures
- BJ Boot Components and components location
- BJ Boot Repair procedures
Front Hub / Knuckle / Tone Wheel Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and ...
Front Driveshaft Components and components location
Components
[Kappa 1.0 T-GDI]
1. Driveshaft (LH)
2. Dynamic damper
3. Driveshaft (RH)
[GAMMA 1.6 T-GDI, Nu 2.0 MPI]
1. Drivesh ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Exhaust Gas Temperature Sensor (EGTS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the connector of exhaust gas temperature sensors #1/#2.
3.
Measure resistance between sensor signal terminal and ground terminal.
4.
...
Hyundai Kona (OS) 2018-2026 Service Manual: Front Door Belt Outside Weatherstrip Repair procedures
Replacement
1.
Pull down the front door window glass to the lowest level by pressing
the power window glass switch.
2.
Using a screwdriver or remover, remove the front door belt outside weatherstrip
(A).
...
