Hyundai Kona: Driveshaft and axle (2WD-FF) / Rear Driveshaft Assembly

Rear Hub - Carrier Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and ...

Rear Driveshaft Components and components location
Components 1. Rear drive shaft (LH) 2. Coupling assembly 3. Rear differential carrier assembly 4. Rear drive shaft (RH) 5. Propeller shaft assembly ...

Other information:

Hyundai Kona (OS) 2018-2020 Service Manual: Ambient Temperature Sensor (ATS) Description and operation
Description Ambient Temperature Sensor (ATS) is installed on the front-end module and senses the ambient temperature. ECM receives not only the intake air temperatue but also the ambient air temperature informations at the same time to control the intake air quantity precise ...

Hyundai Kona (OS) 2018-2020 Service Manual: Filler-Neck Assembly Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Open the fuel filler door. 3. Remove the filler-neck mounting bolt (A). 4. Lift the ve ...

© 2018-2020 www.hkona.com