Hyundai Kona: Lighting System / Turn Signal Lamp Repair procedures

Removal
Front turn signal lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the Daytime Running Light (DRL).
(Refer to Lighting system - "Daytime Running Light (DRL)" )
3.
Remove the bulb socket and then remove the bulb.

Rear turn signal lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bubper.
(Refer to Body - "Rear Bumper")
3.
Loosen the screw and then remove the turn signal lamp assembly.

4.
Remove the turn signal lamp bulb.

Installation
Front turn signal lamp
1.
Install the turn signal lamp.
2.
Connect the negative (-) battery terminal.
Rear turn signal lamp
1.
Install the turn signal lamp.
2.
Install the rear bumper.
3.
Connect the negative (-) battery terminal.
Back-up Lamps Repair procedures
Removal LHD 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bubper. (Refer to Body ...

Door Mirror Lamp Repair procedures
Remove 1. Disconnect (-) battery terminal. 2. Remove door mirror assembly. (Refer to Body - "Mirror" ...

Other information:

Hyundai Kona (OS) 2018-2021 Service Manual: Ignition Coil Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connector (A). ...

Hyundai Kona (OS) 2018-2021 Owners Manual: Detecting pedestrians
The sensor may be limited when: The pedestrian is not fully detected by the camera recognition system, for example, if the pedestrian is leaning over or is not fully walking upright The pedestrian is moving very quickly or appears abruptly in the camera detection area The pedestrian is weari ...

© 2018-2021 www.hkona.com