Hyundai Kona: Ignition Switch Assembly / Back View Camera System Description and operation

Hyundai Kona (OS) 2018-2026 Service Manual / Body Electrical System / Ignition Switch Assembly / Back View Camera System Description and operation

Description

Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.

This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

•	This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.

Back View Camera System Schematic diagrams

Circuit Diagram ...

Back View Camera System Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lide trim. (Refer to Body - " ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Engine oil
Checking the engine oil level (Gasoline engine) 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan. 4. Pull the dipstick out, wip ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Windshield washers
In the OFF (O) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. The spray and wiper operation will continue until you release the lever. If the washer does not work, you may need to add washer fluid to the washer fluid reservoir. ...