Hyundai Kona: Interior Trim / Door Scuff Trim Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the front door scuff trim (A). [Front]

2.	After loosening the mounting screws, remove the rear door scuff trim (A). [Rear]

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Component Location 1. Front door scuff trim 2. Rear door scuff trim ...

Component Location 1. Cowl side trim ...

Hyundai Kona (OS) 2018-2026 Service Manual: RCV Control Solenoid Valve Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the RCV connector. 3. Measure resistance between the RCV terminals 1 and 2. 4. Check that the resistance is within the spec ...

Hyundai Kona (OS) 2018-2026 Service Manual: Crankshaft Repair procedures
Disassembly • Use fender covers to avoid damaging painted surfaces. • To avoid damaging the cylinder head, wait until the engine coolan ...