Hyundai Kona: Cylinder Block / External Damper Flywheel Repair procedures

Removal and installation
1.
Remove the dual clutch transmission.
(Refer to Dual Clutch Transmisson (DCT) - "Dual Clutch Transmisson Assembly")
2.
Remove the external damper fly wheel (A).
Tightening torque :
71.5 - 75.5 N.m (7.3 - 7.7 kgf.m, 52.8 - 55.6 lb-ft)

3.
Install in the reverse order of removal.
External Damper Flywheel Components and components location
Components 1. External damper flywheel ...

Water Jacket Seperator Components and components location
Components 1. Water Jacket Seperator ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Injector Troubleshooting
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from th ...

Hyundai Kona (OS) 2018-2026 Service Manual: Purge Control Solenoid Valve (PCSV) Description and operation
Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapo ...

В© 2018-2026 www.hkona.com