Hyundai Kona: Engine and Transaxle Assembly / Engine Mounting Components and components location

Components

1. Transaxle mounting bracket
2. Roll rod bracket
3. Engine mounting bracket
4. Engine mounting support bracket

Engine Room Under Cover Repair procedures
Removal and Installation 1. Loosen the mounting clip and bolt and then remove the under cover (A). Tightening torque : 3.9 - 5.9 ...

Engine Mounting Repair procedures
Removal and Installation Roll rod bracket 1. Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover&qu ...

Other information:

Ford Fusion 2013–2020 Owners Manual: Adjusting the Headlamps
Vertical Aim Adjustment The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been in an accident, the alignment of your headlamps should be checked by your authorized dealer. Headlamp Aiming Target 8 feet (2.4 meters) Center height of lamp to ground 25 ...

Hyundai Kona (OS) 2018-2022 Service Manual: Knock Sensor (KS) Description and operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pres ...

© 2018-2022 www.hkona.com