Hyundai Kona: Engine and Transaxle Assembly / Engine Room Under Cover Repair procedures

Removal and Installation
1.
Loosen the mounting clip and bolt and then remove the under cover (A).
Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 Ib-ft)

2.
Install in the reverse order of removal.
Engine Cover Repair procedures
Removal and Installation 1. Remove the engine cover (A).    ...

Engine Mounting Components and components location
Components 1. Transaxle mounting bracket 2. Roll rod bracket 3. Engine mounting bracket 4. Engine mounting support bracket ...

Other information:

Hyundai Kona (OS) 2018-2021 Owners Manual: Check tire pressure
You can check the tire pressure in the Assist mode on the cluster. Refer to the "LCD Display Modes" in chapter 3. Tire pressure is displayed after a few minutes of driving after initial engine start up. If tire pressure is not displayed when the vehicle is stopped, "Drive to display" mess ...

Hyundai Kona (OS) 2018-2021 Service Manual: Front Impact Sensor (FIS) Description and operation
Description • The front impact sensors (FIS) are installed on the upper of the side panel in Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at their mounting locations. • The pri ...

© 2018-2021 www.hkona.com