| Inspection |
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the connector of exhaust gas temperature sensors #1/#2.
|
| 3. |
Measure resistance between sensor signal terminal and ground terminal.
|
| 4. |
Check that the resistance is within the specification.
Exhaust Gas Temperature Sensor [EGTS #1, #2 (T3, T4)]
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
terminal.
|
| 2. |
Lift the vehicle.
|
| 3. |
Remove the side under cover.
|
| 4. |
Disconnect the EGTS connector (A).
|
| 5. |
Remove the EGTS (B).
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
terminal.
|
| 2. |
Lift the vehicle.
|
| 3. |
Remove the side under cover.
|
| 4. |
Disconnect the EGTS connector (A).
|
| 5. |
Remove the EGTS (B).
|
| Installation |
|
| 1. |
Install the sensor in the reverse order of removal.
|
Exhaust Gas Temperature Sensor (EGTS) Schematic diagrams
Rail Pressure Sensor (RPS) Description and operationHyundai Kona (OS) 2018-2026 Service Manual: Rear Seat Back Cover Components and components location
Component Location
1. Rear seat back cover [LH]
2. Rear seat back cover [RH]
...
Hyundai Kona (OS) 2018-2026 Service Manual: Front Seat Belt Buckle Components and components location
Component Location
1. Front seat belt buckle
...