Hyundai Kona: Engine Control System / Rail Pressure Sensor (RPS) Description and operation

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

Exhaust Gas Temperature Sensor (EGTS) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the connector of exhaust gas temperature sensors #1/#2. 3. ...

Rail Pressure Sensor (RPS) Specifications

Specification ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: ABS Control Module Repair procedures
Removal 1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable. 2. Separate the intercooler inlet hose (A) from the turbocharger and then remove the inter cooler inlet pipe (B). [Gasoline 1.6 T-GDI] ...

Hyundai Kona (OS) 2018-2026 Service Manual: Stop Lamp Switch Repair procedures
Adjustment 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the lower crash pad. (Refer to Body - "Crash Pad") 3. Confirm the gap between stop lamp switch a ...