Hyundai Kona: AVN System / External AMP Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body Electrical System / AVN System / External AMP Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front passenger seat. (Refer to Body - "Front Seat")

3.	Remove the external AMP (B) after loosening the mounting nuts and disconnect the connector (A).

Installation

1.	Install the external amplifier after connecting the connector.

2.	Install the right luggage side trim.

Connect the negative (-) battery terminal.

•	Make sure that the cables and connectors are plugged in properly.

•	Check the AVN system.

External AMP Components and components location

Components NO Connector A NO Connector B 1 BATT (+) 1 Rear door speaker - LH (+) ...

AVN Remote Controller Components and components location

Components 1. Left Remote Control Switch (Audio + Hands free) 2. Right Remote Control Switch (Cruise+Trip Computer) ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Schematic diagrams
Schematic Diagram Canister The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set. Purge Control Solenoid ...

Hyundai Kona (OS) 2018-2026 Service Manual: Alternator Specifications
Specification ltem Specification Nominal output 13.5V, 130A Speed in use 1,000 - 18,000 rpm Voltage regulator IC Regulator built in type Regulator Setting Vo ...