Hyundai Kona: Blower / Intake Actuator Description and operation

The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.

Intake Actuator Components and components location

Components Location 1. Intake actuator ...

Intake Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Rear Seat Latch Repair procedures
Replacement [LH]    • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the relat ...

Hyundai Kona (OS) 2018-2026 Service Manual: Brake Line Repair procedures
Removal Brake Tube [VDC Control unit ↔ Master cylinder] 1. Turn ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the brake fluid level switch connector (A) 3. Remov ...