Hyundai Kona: Interior Trim / Luggage Side Trim Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat assembly
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Carefully remove the rear door body side weatherstrip.
3.
Carefully remove the tail gate weatherstrip.
4.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
5.
Remove the rear transverse trim.
(Refer to Interior Trim - "Rear Transverse Trim")
6.
After loosening the mounting screws and clip, remove the luggage side trim (A).

7.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).
Rear Transverse Trim Repair procedures
Replacement    • Put on gloves to prevent hand injuries. ...

Rear Pillar Trim Components and components location
Component Location 1. Rear pillar trim ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the sp ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Non-operational conditions of Parking Distance Warning (Reverse) system
The Parking Distance Warning (Reverse) system may not operate normally when: Moisture is frozen to the sensor. Sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. There is a possibility of the Parking Distance Warning (Reverse) system malfunction when ...

© 2018-2026 www.hkona.com