Hyundai Kona: Interior Trim / Rear Transverse Trim Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Transverse Trim Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the luggage covering bord (A).

2.	Remove the luggage floor center tray assembly (A).

3.	Loosen the mounting clips and remove the rear transverse trim (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Rear Transverse Trim Components and components location

Component Location 1. Rear transverse trim ...

Luggage Side Trim Repair procedures

Replacement • Put on gloves to prevent hand injuries. ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Distributing the sealant
9. Immediately drive approximately 7~10 km (4~6 miles or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 80 km/h (50 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride disturbance or ...

Hyundai Kona (OS) 2018-2026 Service Manual: Fender Garnish Repair procedures
Replacement • Put on gloves to prevent hand injuries. • Wh ...