| Inspection |
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 3. |
Disconnect the motor connector (A) from the motor.
|
| 4. |
Connect the terminal No.1 and No.2 to battery voltage (12V) and
check that the motor operates smoothly when connecting the terminals
below.
[Safety Window Motor]
|
| 5. |
Connect the motor terminals directly to battery voltage (12V) and
check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[Standard Window Motor]
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
| 3. |
Disconnect the motor connector from the motor.
|
| 4. |
Connect the motor terminals No.1 and No.2 directly to battery voltage
(12V) and check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Standard Window Motor]
|
Power Window Motor Schematic diagrams
Power Window Switch Components and components locationHyundai Kona (OS) 2018-2026 Service Manual: Brake Pad Repair procedures
Replacement
Front Brake Pad
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
...
Hyundai Kona (OS) 2018-2026 Service Manual: SRSCM Components and components location
Components
1. Front right Pressure Impact
Sensor (FIS)
2. Supplemental Restraint System Control Module (SRSCM)
3. Front left Pressure Impact Sensor (FIS)
4. Pressure Side Impact Sensor
(P-SIS
5. Gravity Side Impact Sensor (G-SIS)
...