Hyundai Kona: Rear Bumper / Rear Bumper beam Assembly Components and components location

Hyundai Kona (OS) 2018-2021 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly Components and components location

Component Location

1. Rear bumper beam assembly


Rear Bumper Cover Repair procedures
Replacement    • Put on gloves to prevent hand injuries. ...

Rear Bumper beam Assembly Repair procedures
Replacement    • Put on gloves to prevent hand injuries. ...

Other information:

Hyundai Kona (OS) 2018-2021 Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal [Tortion Beam Axle Type] 1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable. 2. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. ...

Hyundai Kona (OS) 2018-2021 Owners Manual: Manual adjustment
Forward and rearward adjustment To move the seat forward or rearward: 1. Pull up the seat slide adjustment lever and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sure the seat is locked in place. Move forward and rearward without using the lever. If the seat ...

© 2018-2021 www.hkona.com