Hyundai Kona: Cooling System / Reservoir Tank Repair procedures

Removal and Installation
1.
Loosen the drain plug and drain the coolant and remove the radiator cap to speed draining.
(Refer to Cooling System - "Coolant")
2.
Disconnect the over flow hose (A) and cooling hose (B).
3.
Remove the resevoir tank (C).
Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 Ib-ft)

4.
Install in the reverse order of removal.
Radiator Repair procedures
Removal and Installation 1. Loosen the drain plug, and drain the coolant and remove the radiator cap to speed draning. (Refer to Cooling System - "Coo ...

Water Temperature Control Assembly Components and components location
Components 1. Water temperature control assembly 2. Water temperature sensor 3. Heater pipe gasket 4. Heater pipe ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Fuel Pump Control Module (FPCM) Description and operation
Description The fuel pump control module (FPCM) is installed on the right side of the fuel tank and controls the DC motor mounted inside the low pressure fuel pump.The module compares instantaneous fuel pressure information measured by the fuel pressure sensor (FPS) with tar ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Sliding the sunroof
Pressing the sunroof control lever backward or forward momentarily to the second detent position completely opens or closes the sunroof even when the switch is released. To stop the sunroof at the desired position while the sunroof is in operation, press the sunroof control lever backward or forw ...

В© 2018-2026 www.hkona.com