Hyundai Kona: Brake System / Vacuum Pump Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Check the safty after uplift the vehicle with lift.
3.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
4.
Disconnect the vacuum pump connector (A).

5.
Remove the fixing clip and then seperate the vacuum hose (A) from the vacuum pump.

6.
Loosen the mounting bolts and then remove the vacuum pump (A).
Tightening torque :
19.6 - 29.4 N.m (2.0 - 3.0 kgf.m, 14.4 - 21.6 lb-ft)

Installation
1.
To install, reverse the removal procedure.
Vacuum Pump Schematic diagrams
Schematic Diagrams Terminal function Terminal Description Wire color 1 Ground Black ...

Master Cylinder Components and components location
Components 1. Reservoir cap 2. Reservoir 3. Reservoir pin 4. Grommet 5. Master cylinder ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Special service tools
Special Service Tools Tool (Number and name) Illustration Use 09880-4F000 Hog ring clip installer Hog ring clip installation ...

Hyundai Kona (OS) 2018-2026 Service Manual: Driver Airbag (DAB) Module and Clock Spring Components and components location
Components 1. Driver Air Bag (DAB) 2. Steering Wheel 3. Clock Spring ...

В© 2018-2026 www.hkona.com