Hyundai Kona: Heater / Auto Defoging Actuator Description and operation

Description
The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mode actuator.
Auto Defoging Actuator Components and components location
Components Location 1. Auto logging actuator ...

Auto Defoging Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Automatic reverse
If a window senses any obstacle while it is closing automatically, it will stop and lower approximately 30 cm (12 inches) to allow the object to be cleared. If the window detects the resistance while the power window switch is pulled up continuously, the window will stop upward movement then lowe ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Hood
Opening the hood 1. Park the vehicle and set the parking brake. 2. Pull the release lever to unlatch the hood. The hood should pop open slightly. 3. Go to the front of the vehicle, raise the hood slightly, push the secondary latch up (1) inside of the hood center and lift the hood (2). 4. Pull ou ...

В© 2018-2026 www.hkona.com