Hyundai Kona: Charging System / Battery Sensor Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures

Removal

1.	Disconnect the battery negative (-) cable.

2.	Turn the ignition switch OFF.

Disconnect the battery (-) terminal (A).

Battery negative (-) terminal tightening nut :

4.0 - 6.0 N.m (0.4 - 0.6 kgf.m, 3.0 - 4.4 lb.ft)

4.	Remove the battery sensor (B) after loosening the mounting bolt (A).

Installation

Install in the reverse order of removal.

•	For the vehicle equipped with a battery sensor, be careful not to damage the battery sensor when the battery is replaced or recharged.

1)	When replacing the battery, it should be same one (type, capacity and brand) that is originally installed on your vehicle. If a battery of a different type is replaced, the battery sensor may recognize the battery to be abnormal.

2)	When installing the ground cable on the negative post of battery, tighten the clamp with specified torque. An excessive tightening torque can damage the PCB internal circuit and the battery terminal .

3)	When recharging the battery, ground the negative terminal of the booster battery to the vehicle body.

Battery Sensor Recalibration Procedure

After reconnecting the battery negative cable, AMS function does not operates until the system is stabilized, about 4 hours. If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with AMS function, Battery sensor recalibration procedure should be performed after finishing the repair work.

1.	Turn the Iginition switch ON and OFF.

2.	Park the vehicle for about 4 hours with the hood and all doors closed.

Battery Sensor Description and operation

Description Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors. It is important to have a ...

Starting System

...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Roof Side Molding Repair procedures
Replacement • Put on gloves to prevent hand injuries. • Wh ...

Hyundai Kona (OS) 2018-2026 Service Manual: Power Door Lock Switch Repair procedures
Inspection Power Door Lock Switch Inspection 1. Check for continuity between the terminals. If there is an abnormality, replace the switch. Removal ...